05-up Question about grills

CopperTopp · Sep 1, 2008

Hi, Just wondering if anyone knows if the SAP grills will fit an SES non SAP?

I love how the ford logo is smaller, and I LOVE the sizing of the diamond meshing.

Ultimately, I'd be happy with that mesh with no logo, in the lower grill area (open part below license plate), and the upper grill. So my next question is:

Will the lower SAP grill fit (being cut down) into the NON SAP bumper lower grill area?

THANKS in advance.

Ohh, also, if the above will not work...does anyone know what vehicle I could get a similar plastic mesh that WILL fit (with modifications)...or is there an aftermarket very similar? I want to avoid using steel.

THANKS again.

Sn4ckM4st3r · Sep 1, 2008

This grille may not be the same design but the ST grille is a direct swap i think. Easy to color match the outside and has a different pattern for the plastic in the middle. May look into that maybe just paint the logo black.

If that works then contact mike at hilbish ford for one.

Sn4ckM4st3r · Sep 1, 2008

Also forgot i think the SAP grille may be part of the whole front fasica. Not sure thoguh.

NickDaBear · Sep 1, 2008

no both upper and lower come out........I had taken out both and replaced with mesh.....couldnt get the upper to look right to replaced the stock one on top and just Used Flat black spray paint and "Smoked" it out...looks nice IMO

Jackal43 · Sep 2, 2008

These will not fit into a non-sap grille the center piece of the sap grille is assembled way different than non-sap

Ezpimpin · Sep 2, 2008

it's much different, I swapped my stock fascia for s.a.p. and I can assure that it's not possible.

CopperTopp · Sep 3, 2008

Thanks guys. I'm just gonna make new mesh. I found plastic sqaured shit, but I'll just turn it on its side, so It's diamond.

DarkFire1986 · Sep 3, 2008

Share some pics when you get done.

05-up Question about grills

Our Vendors

Top Contributors this Month

Recommended Communities