Torque mount. Both through bolts 35 ftlbs.

 

Motor mount. Lower bracket. The 3 bolts:35 ftlbs. To engine 66 ftlbs.

 

Idler pulley. 18 ftlbs. No spec listed for the tensioner in my Haynes.

 

Stabilizer bar clamp bolts 41 ftlbs. The link nuts are 41 as well.

 

THANKS A MILLION for all your help. Was able to get it all done the other day. Car rides like new again!!!

 

Torque Specs - Zetec Engine

here's all the TQ for the engine on a zetec. the link doesn't work because you have to pay for ALLDATA but I got all of the info at school where we have access to it. it's basically every TQ spec required to assemble a zetec. also, I can put up larger pictures next week as well. also, I'll save...

www.focaljet.com

Suspension Torque Specifications

Front: Control arm bolts - Step 1 (inner rear nut, #1): 74 lb-ft Step 2 (inner rear nut, #1): Tighten an additional 60 degrees Step 3 (outer rear nut, #2): 89 lb-ft Step 4 (front bolt, #3): 89 lb-ft Step 5 (front bolt, #3): Tighten an additional 90 degrees Step 6 (front bolt, #3): Check...

www.focaljet.com

Good references.