Focus Fanatics Forum banner

How-To: SVT Side Mirror Installation

23K views 19 replies 15 participants last post by  A Focused Family  
#1 ·
Items Needed:
1) Two SVT Side Mirrors (Will require painting) Part# FO1320314 (Left) & FO1321314 (Right)
2) Socket/Ratchet
3) Torx Screwdriver


Image

Image



Step 1:
Remove the plastic cover. Start by gently pulling/lifting the backside and then pull the cover off.
Image

Image



Step 2:
Using a Torx Screwdriver, remove the mounting screw.
Image



Step 3:
Unplug the Mirror.
Image



Step 4:
Remove the rubber grommet. This thing falls off really easy so be careful.
Image



Step 5:
Use a socket/rachet and remove the second mounting bolt. You will need to remove the foam insullation for easier access.
Image



Step 6:
Remove the old side mirror.
Image



Step 7:
Feed the wires from the new mirror through the hole.
Image

Image



Step 8:
Reinstall the rubber grommet.


Step 9:
Reinstall the side mirror.


Step 10:
Install the painted mirror caps. "I had a clear film installed to protect the pain against rock chips."
Image



Keywords: svt mirror install, svt mirrors installation, svt side mirrors how to, svt mirror how to
 
#2 ·
Awesome post, Tom!

It should be noted that the screw is a Torx screw (at least mine is). I think it's a T15. Also the socket is a 10mm and the SVT doesn't reuse the Torx screw.
 
#4 ·
great writeup tom! im going to need this in about three weeks!

+rep!
 
#11 ·
I can answer the question whether the heated function works. It does not on an 00-02, but does on >03.

Of course, I learned the hard way. Does anyone know which wires to tap into to get the heated function to work? I'm assuming I can tie into the rear window heat button but where to go on the other end? Anyone?
 
#14 ·
Where did you order them from?
 
#16 ·
I have a 2000 and I have a non motorize mirror...there is a plastic cylinder that holds the 3 guide wires together where the interior controlling stick is. I can't get the mirror out with that on, but it wont come off...help!![wiggle]
 
#17 · (Edited)
Hey, thanks for these photos, I think they will really help me, I have to replace the passanger mirror, my wife met the trash can backing out of the garage. Now, I know it is electric, but what tells me if the mirror is heated? PN 98AB17682-M and -L on inside vane trim of mirror. The plug coming in to mirror is 5 wire, the plug going to mirror is three wire.
 
#18 ·
SVT Torx?

The SVT definitely does not use a Torx...what does it use? I'm trying to replace my passenger side and I can't see in there to verify what bit it takes. Any clues?
 
#19 ·
Nevermind, the SVT only has the 10mm....