Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I put an led bulb in my tail light and added a resistor to the blinker circuit, it blinks fine.... until I turn my lights on, then it hyper flashes and the led just stays on solid. There is also no difference in the brake lighting it just stays bright. Is there a resistor that needs to be added to the brake circuit too? From what I understand the original bulb is a dual filament.
 

·
Vince your Moderator
Joined
·
5,074 Posts
Remove the LED bulb and turn it 180 degrees and reinstall it.

Do this one bulb at a time and test it.

Post results
 
1 - 3 of 3 Posts
Top