Focus Fanatics Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
ok guys i want to wire the a/f gauge to my ecu wires not the o2 wire i dont want to hassel goin through the firewall unless theres already a hole to go through....

also what pin or wat wire to wire the a.f gauge to.....
 

·
The Librarian
Joined
·
13,116 Posts

·
Registered
Joined
·
248 Posts
i dont kno what wire to wire it to but i kno there are holes in the firewall you can get it through just got to find it.....dont kno if that helps
 

·
Registered
Joined
·
122 Posts
Actually, there is a spot where you can go through the firewall with a small guage wire. You can feed the wire through the grommet through which your hood latch release cable goes. It's a real pain to do, but it can be done, I ran a single 16ga. wire through this grommet. The rubber grommet will also protect from any chaffing of the wire. Just an idea.
 

·
Registered
Joined
·
11 Posts
i found a hole in the firewall big enough to run my power wire from my amp to my battery...it was located up behind one of the pedals on the driver side you just have to pull up the carpet and look around for it...if worse comes to worse i can e-mail you a pic of where the hole is so you can find it easier....
 
1 - 5 of 5 Posts
Top