Focus Fanatics Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
264 Posts
Hi all! Putting my 05 Focus ZX4 5 speed back together after replacing a bad clutch slave cylinder. Getting near the end of the job, I found this wire. I'm guessing it's a ground, not sure on that. The connector has been snapped off.

Can anyone tell me where it goes and what type of connector I should solder onto it? Thanks so much in advance!

1st pic is where the wire leaves the harness, above the transmission, 2nd is the end of it.

View attachment 315168
View attachment 315167
If it's just a single wire it's probably the starter trigger wire

Sent from my SM-G970U1 using Tapatalk
 
1 - 1 of 1 Posts
Top