Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I have a 2000 ZX3 and need some help from owners with the same or equivalent model. Your vehicle will need to be lowered 1.5" (1.25"-2.00" is acceptable but please specify in any case).

I need a measurement taken from the wheel center to the inside lip at the apex of the rear fender. The vehicle should have a full interior and measurements with a full and half tank would be very helpful but any will suffice. Again please specify.This needs to be relatively accurate so I'm looking for measurements being repeatable within at most 1/16th of an inch (metric would be better). I'd like several owners' input if possible.
 

·
Registered
Joined
·
17 Posts
Discussion Starter · #2 ·
bump

Edit: I'll add that my vehicle is a shell right now and I'm unable to just measure the factory ride height and subtract the lowering value in case anyone was confused.
 
1 - 2 of 2 Posts
Top