Focus Fanatics Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
I have looked (even in my repair manual) for the vacuum hose diagram for my zetec engine.

Can anyone help? Need pics even if it's a PDF file [?|]

Thanks!
 

·
Registered
Joined
·
471 Posts
I didn't know what engine you had so here is for Zetec and SPI. (shoot me rep if i helped [wrenchin] )

SPI Vacuum Diagram


Zetec Vacuum Diagram

 

·
Registered
Joined
·
242 Posts
Discussion Starter #3
Thanks! That was quick! This is very helpful & sorry, my signature stuff isn't popping up under my posts. I have the zetec engine.

I am thinking of doing the HHO gas thing and needed to see where everything was to hook it up.
 

·
Registered
Joined
·
11 Posts
Thanks! That was quick! This is very helpful & sorry, my signature stuff isn't popping up under my posts. I have the zetec engine.

I am thinking of doing the HHO gas thing and needed to see where everything was to hook it up.
let me know how this goes, I was thinking for a long time about doing it too but i am hesitant, I got a motorcycle engine that im will be trying plasma spark on this summer probably though =)[headbang]
 

·
Registered
Joined
·
242 Posts
Discussion Starter #6
let me know how this goes, I was thinking for a long time about doing it too but i am hesitant, I got a motorcycle engine that im will be trying plasma spark on this summer probably though =)[headbang]
Sorry for the late comeback raisdfist but it worked well....for about 3 days. I pushed 53MPG then the tower had a meltdown and I haven't replaced anything yet, been too busy with other issues. Hope this helped even tho I was late on the response. [cheers]
 

·
I need BOOOOST!!!!!!
Joined
·
6,125 Posts
just curious but is HHO gas like a hydrogen injection kit? got any pics?
 

·
Registered
Joined
·
242 Posts
Discussion Starter #8 (Edited)
just curious but is HHO gas like a hydrogen injection kit? got any pics?
This is a picture (not completely wired) of the HHO installed in the engine compartment. It is sitting on a fabricated base and bracket. Also, here is the wiring diagram for it, I bought everything off Ebay for around $30, and yes, it's like a hydrogen injection kit.

After all is installed all you need to get is DISTILLED WATER (gallon jug goes a long way) and a box of BAKING SODA (only use 1/4 to 1/2 teaspoon or you will have a major meltdown like I did (see picture below), notice the plexiglas on the top notch, too much baking soda caused more juice than needed, melted the notch and made contact with the negative side)

Hope this helps you out focusmaniaczx3!



 
1 - 12 of 12 Posts
Top