Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
I was wondering if anyone has installed a trans temp gauge in a Duratec Focus with automatic transmission?
Where would the best place be to tap from?

I also have a turbo boost gauge that I want to use to fill the third hole in my pillar post. Where would the best place be on the motor to tap vacuum from so at least I can use the boost gauge for a vacuum gauge?

I have a 2007 ZX3
 

·
Registered
Joined
·
1,410 Posts
Some places sell adapters that fit onto your tranny drain. For example when i purchaced my turbo kit for my Duratec it came with an oil drain kit and with this kit it allows for an extra line to check oil pressure or oil temp.
You have a turbo on ur car? Or is it just a vacuum gauge? What type of gauge is it, who makes it? Does the gauge come with a sender unit or solonoid of some sort? Should be able to tap into the intake manifold.
 

·
BodyKits=PantiesDrop
Joined
·
13,168 Posts
it depends on if it pulls electronically from the MAP sensor or if it has a vacuum sending unit dealio
 
1 - 3 of 3 Posts
Top