Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Captain TMI
Joined
·
21,235 Posts
Discussion Starter #1
OK... I know I'm a weirdo.. everyone else wants to go fast, but I want to save cheese on the highway that I spend so much time on. At least with this motor.

The car is a 2005 2.0 ZXW with a 5 spd. I'm assuming this is the same MTX-75 that Ford has been using since the Contour.

Marcy Motorsport markets a 3.41 ring and pinion gear for the Focus, which I'd like to replace my 3.82 with for a long trip to CA. However.. Marcy is closed until July 21, and I'll be leaving sometime around them- no sense in getting a gear I can't install for a long trip.

Does anyone know who Marcy gets their gears from, or know of another vendor who markets the same gear or a similar "tall" gear. I'm doing some searching but help would be apprectiated[thumb]

Sorry if I posted in the wrong place Amanda, I didn't see a drivetrain forum!!!

Thanks in advance!!!
 

·
Registered
Joined
·
8,506 Posts
i havent torn into looking into much tranny stuff as of yet for my foci, only grazed across the flywheel and clutch package.

but ill keep an eye out.

and ~bump~ for help on the thread getting not getting barried.
 

·
Registered
Joined
·
1,797 Posts
The cost of the install would greatly outway any possible improvements in highway fuel economy.
 
1 - 3 of 3 Posts
Top