Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Mtn. Dew
Joined
·
7,223 Posts
Discussion Starter #1
I've got a 65mm tb from Focus Central to install on my car. It says you should port the intake to 65mm.
Did everyone else who put one on port the intake?

I was thinking of purchasing a Dremel for this. Is this the best tool for this job? Will it work?
I would appreciate any advice from people who have done this b4.
 

·
Registered
Joined
·
798 Posts
Yeah it'll work. The only other thing you need is some grease. Put some greasey towels down the tube to prevent anything from getting down there. The plastic bits are ok but sandpaper grit can cause some serious problems. When you take the stock T/b off be carefull with bolts and screws too. I'm pretty sure there is a "How to" somewhere on the web.
 
1 - 2 of 2 Posts
Top