Focus Fanatics Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter #1
Not a question just a comment: I got the tranny in, went to bleed the slave and fluid started leaking out of the bottom of the tranny. Pulled the tranny, the slave was off center and stuck all the way back. I'm thinking I pulled it off center when I put the tranny back in and maybe lowered the tranny a little too much and the weight of the tranny bent the slave shaft. This time I've got the K-member lowered much further down, and hope to have a straighter shot in. I will take any advise on getting it straight though.
 
1 - 1 of 1 Posts
Top