Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter #1
I'm trying to figure out the best way to install SVT skirts on my 07 sedan. Looks like there is one existing screw underneath near the front and 2 in the rear wheel well. Could I just use those 3 existing holes and then run some 3m tape along the top and bottom of the rocker? I'd rather not drill any new holes if I don't have to. Just wanting some opinions/advice from others that have done this before.
 
1 - 2 of 2 Posts
Top