Focus Fanatics Forum banner
1 - 1 of 1 Posts

8 Posts
Discussion Starter · #1 ·
Im in the process of wiring everything up to do the intake manifold swap and i am thinking i got the wrong pigtail. I already have the MSD digital window switch. I have already studied the wiring digram in the main write up but have questions

Below are the wire from the pig tail. if looking at the back of the connector with the lock on top the wires are as shown


NO WIRE-------BLK/BLU--------WHT/RED

According to the diagram, you have one blk/wht going to the msd for control, and another blk/wht as a ground Which one coming out of the pig tail is the ground?

Also in the diagram, it shows a BLU/WHT wire going to pig tail doesn't have that. What other remaing wire goes to ground in my pig tail.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.