Focus Fanatics Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter #1 (Edited)
I have a K&N short ram intake. I just bought a strut tower bar, put it on, and it hits the intake. Not a real problem, but it makes the intake sit at an angle. It's still hooked on good to the throttle body... it's just not 'pretty.' Would this cause any problems? Any sugestions on how to fix this? [???:)] [?] Below is a picture of what is happening.

Edit: Actually found a broblem! When comming to a stop the bar and intake rub aganst each other... thought I might just get a plate that says 'Killer Bee' or something. [confused]


 

·
Registered
Joined
·
83 Posts
xdrakos said:
Ii. Not a real problem,
.

You awnsered your own question.
 

·
Registered
Joined
·
68 Posts
Discussion Starter #3
Just wanted to see if anyone disagreed with me, I guess. LOL, and I guess I did answer my question two word after I asked it! [:D]
 

·
Registered
Joined
·
8,023 Posts
Really depends on how much the motor moves back and forth under torque loads. Its the intake that will be hitting the back as the motors rocks.You might want to replace the bushings in the rear engine mount or replace with a new MAC or VF rear mount.
 
1 - 4 of 4 Posts
Top