Focus Fanatics Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi, I am working on my 2007 ford focus zx4 5 speed manual, I had done some work to my shift tower because the pin had sheared off inside, after I got that all fixed I was bleeding and boom! Master cylinder gone... so I get that all replaced and switched out and I am bleeding again.... (pain in the but) I go to tighten up the bleeder valve and it strips, won't close and is stuck open. This car is becoming a nightmare an I was wondering how easy or if possible to get that bleeder valve out or just some info!
Thanks,
Chris
 
1 - 1 of 1 Posts
Top