Focus Fanatics Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
278 Posts
Discussion Starter #1
K, so i just got my eibach pro kit installed, and I have 18 inch enkei rs7's with 215x35x18 BFG KDW2's on there too. I was hittin some corners and on the front right side i'm getting a scraping noise, I have no clue what it is. I checked and everything is bolted together right, and I'm not getting this scraping on the left side yet. Any ideas?
 

·
Registered
Joined
·
278 Posts
Discussion Starter #3
why would that only be on one side tho? the struts have to align the same way on each side...
 

·
Detailing Freak
Joined
·
348 Posts
have you gotten an alignment?

what were the alignment specs, before and after, mainly after though

what offset rims are they?

only in corners, or on big bumps too?
 

·
Registered
Joined
·
2,928 Posts
why would that only be on one side tho? the struts have to align the same way on each side...
I've used different set-ups and any rubbing has always been my left front and right rear. Nobody knows why. It just happens. I did a little fender roll and made it better. I'll still get a touch once in a while.
 

·
Registered
Joined
·
278 Posts
Discussion Starter #6
45mm offset, and i haven't gotten an alignment yet because i still gotta put my sways in.
big bumps too
 
1 - 6 of 6 Posts
Top