Focus Fanatics Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
I'm pulling an '02 Focus engine at the junkyard this weekend, and need to pull it up (not drop it down). Do I need to completely remove the tranny first, or can it remain attached to the car at the mounts and axles?
 

·
Registered
Joined
·
636 Posts
? no. I cant see that being possible with the axles still attached at all but it only takes a few minutes to get the axles off as well as the mounts.
 

·
Registered
Joined
·
1,486 Posts
The engine/tranny hang from the mount on the drivers side, so the only way to go up would be to disconnect the engine from the tranny......
 

·
Registered
Joined
·
636 Posts
mmm, it has been a few since i did the engine swap but if I remember correctly I got the engine out of the top with the ATX still attached, it was tight but we got it through with some maneuvering...
 

·
Registered
Joined
·
1,380 Posts
cut the bracket that holds the drivers engine mount. not like they can sell that always. then going up shouldn't be too hard.
 
1 - 6 of 6 Posts
Top