Focus Fanatics Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
Anyone ever had to replace the rear knuckle? I'm looking for a how to or just a heads up on any problems I might run into... Already have the part ready (The knuckle currently on there is bent hence the replacement. The spindle and bearing are all fine though it's further up on the knuckle that it's bent. Damaged was caused by a rather rude cement wall... I guess it's better then hitting the highway below).
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top