Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i changed the crank sensor, all fuses showing power but when i go to start it just cranks. im not hearing the fuel pump used starting fluid but it still just cranks. i had several mechanics and electricians come and check it out n spent lots of money on new parts to get the same result. its not reading the diagnosis either. The box below the mph gauge just has dashes straight across please assist
 

·
Premium Member
Joined
·
44,595 Posts
Moved to it's own thread in General Tech Chat

Bad or unhooked ground at one of the small wires to/near the battery is a typical cause for this - PCM isn't working without it's ground.

(Possible power problem, but ground is the common one)
 

·
has a screw loose
Joined
·
9,927 Posts
I had dashes at 1 point with mine and the ECU had been erased , got it reflashed at the dealership and it started right up and no problems anymore. But my dashes were due to a tune not fully uploading to the ECU.
 
1 - 3 of 3 Posts
Top