Focus Fanatics Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter #1
So finally after digging into this forum and going back and forth to auto zone, I have successfully stopped the hyper flashing for my led turn signals on the front and back by installing (the correct) resistors! If anyone is puzzled then look at the base of your turn signal bulb connection and it should have an arrow, MIN, and MAJ somewhere on there. MAJ and the arrow (ground) need to have the resistors ends spliced into them or soldered preferably. Thank you fofo for your amazing helpful knowledge!
 
1 - 1 of 1 Posts
Top