Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
ive been trying all day to get these installed. but i keep blowing the fuse. im not an electrical genius or anything. i havent seen a how to on these yet. the main problem i am having is getting the brake light and turn signal to work. the wiring on the tails i have now have 3 wires, 1 for the brake, 1 for the turn signal and the ground. i tried to splice wires together and soldering them together. should i buy a bigger fuse and hope for the best? i dont want to burn out the wiring by getting a bigger fuse. im open to any suggestions

bri
 

·
FF Founder
Joined
·
20,121 Posts
Remember the Euro lights uses the Reverse lights section(North American lights) as their blinkers so you will need to connect to that.

I would use T-Clamps instead of splicing it.

I can't remember 100%, but I believe the blue wire is the brake & blinker wire.

You would also use T-Clamps on the other end as well. Then use a wire with a Male connector on each end to connect them together.
 

Attachments

1 - 3 of 3 Posts
Top