You machinist should know better then to go by the heads height and be cc`ing it to see what the cc`s are not how much has or might of been cut already
Tom
Tom
Need cylinder head height specs
I need to know the stock specs of the head so my machinist knows how much we can deck. It's not listed on the AERA system and I don't know the history of the head, if it's a virgin or not. i'd like to know before I go too far with it.
I gave him the only 2 #'s on the head, one is a part #, ends in AB, always a Ford part number indication. The other is, Q6PHA, which I assume is a casting number, but it's not in the system.
Also need those specs to double check the valve specs to have them 3 angled.
Any help will help.
I gave him the only 2 #'s on the head, one is a part #, ends in AB, always a Ford part number indication. The other is, Q6PHA, which I assume is a casting number, but it's not in the system.
Also need those specs to double check the valve specs to have them 3 angled.
Any help will help.
1 - 1 of 4 Posts
1 - 1 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Focus Fanatics Forum
A forum community dedicated to Ford Focus owners and enthusiasts. Come join the discussion about SVT performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
