Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So I have an 07 5spd SES sedan and the lovely roll pin issue kept reoccurring. I finally had enough, and bought a whole new tower from Ford, but I have a problem. Both the vent cap and the electrical connector aren't on the new tower. How would I go about switching over the vent cap? Is the electrical connector just for the shift light on the dash, or is it also used for things like the reverse lights? I normally would've just kept putting bolts in, but I'm a pizza delivery driver, and it only seems to break while I'm working. I try to be careful with the car, but sometimes I get a bit aggresive when it is busy. Sorry in advance if this has been dealt with before, but I'm just tying to finish this up quickly.
 
1 - 2 of 2 Posts
Top