Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
238 Posts
Discussion Starter #1
I'm wondering what type of nuts hold the projector to the Mach HID housings as I'm buying a set but it may or may not have the nuts that hold the projectors in and wanted to know if I could just go to lowes and pick some that match up.

Any help is appreciated.
 

·
PARTS HUNTER
Joined
·
3,001 Posts
Well they are nuts not screws. The chrome housing has 4 studs on the back. And only 3 nylon lock nuts go on the studs 1 is not used. I think the nut size was 7mm(that's the socket size I used to loosen) but I don't know what thread pitch tho.
 

·
Registered
Joined
·
238 Posts
Discussion Starter #3
Well they are nuts not screws. The chrome housing has 4 studs on the back. And only 3 nylon lock nuts go on the studs 1 is not used. I think the nut size was 7mm(that's the socket size I used to loosen) but I don't know what thread pitch tho.
Thank you! I had actually just looked at a disassembly guide and realized they were nuts and not screws. Couldn't edit this in time to not seem like an idiot.
 
1 - 3 of 3 Posts
Top