[slammedi'am]

Finally got the head pulled on my car....Jumped time on my buddy and killed all the exhaust valves...While I have it all apart and waiting on machine shop, what else should I do/replace before I finish it up...

This is what I have so far Im gonna replace..

-Tstat & housing
-Belt & tensioner
-Timing belt
-Water pump
-Plugs,wires and coil
-Cam sensor
-Upper n lower rad hoses and other hoses

Car has 105k miles on it and was took care of...I wanna replace a lot of this while its easy access...Its just gonna be a daily driver so not going crazy hp on it

 

[slammedi'am]

Also on the exhaust valves,is there another source for these besides Ford???

 

[1turbofocus]

Your cam sensor should be fine

I would do the motorcraft SP463 plugs

I would also do the ARP head studs , make sure you TQ then 6-8 times and use the molly lube and TQ specs for the molly

Tom

 

[zetecDon]

Moved to "General Technical Chat" since your questions pertain to general maintenance.

 

[Mandroid]

You must be the only other Shane in the U.S.



I think you should check your tie rod ends and ball joints at 100k.