Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
538 Posts
Discussion Starter #1
I recently purchased a 2.3l head for my 2.0. From what I read it was going to be a straight swap, but then I found out that I will need new inlet and exhaust valves. All in all with the valves, bare head, port and polish, and install; I will be looking at about $650. Will this be worth it........
 

·
Registered
Joined
·
1,797 Posts
not unless you are building a high compression or high boost motor with all of the supporting mods like cams, etc
 

·
Registered
Joined
·
301 Posts
yeah, the stock head is capable of alot of HP. if you want to see much benefit from any kind of headwork then youd need to be flowing alot of air. more than you could with all the bolt ons.
 
1 - 3 of 3 Posts
Top