Focus Fanatics Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter · #1 ·
hey guys ive been a lurker for awhile and i just finished the build on my car. is a simple zx3 with forged bottom end, (built by diamond racing solutions) stock head, and a second hand focus power turbo kit. i have the kit itself on the car but none of the boost/vacuum lines have been run because i dont know what goes where. same thing goes for the boost controller. do i run a line from the tip on the waste gate strait to a gauge? does it go to the boost controller? does everything on the kit with a tip for vacuum/boost line run to a single vacuum/boost block and then have additional ones run from there to the boost gauge and boost controller? i have NEVER had a turbo car before and am totally ignorant to everything to do with them except i know to let the car idle for awhile before shutting it off so oil doesnt pool in the turbo or something like that.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top