Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
While trying to change the LEDs in my heated seat switches, i noticed that the white seat icon is supposed to be illuminated when the lights are on. There was an LED in place for it but it wasn't wired up, just like the door lock switches originally didn't light up. I am curious as to how to wire them. Has anyone done this? I found a thread with a link to a how-to:

(http://www.focusfanatics.com/forum/showthread.php?s=&threadid=64899

but unfortunately the site is down.

I my guess would be that the wires should attach to the two unused leads on the back of the switch. There is a wiring harness that attaches the two switches to the main power inside of the console. I am unsure of which terminals I should plug the wires into though. I do not want to cause any electrical problems.

Any help is appreciated.
 

·
Registered
Joined
·
64 Posts
Discussion Starter #2
bump.
 

·
Registered
Joined
·
64 Posts
Discussion Starter #3
bump ^
 
1 - 3 of 3 Posts
Top