Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So I have a 03 focus zx3 2.0 zetec dohc manual. And long story short I blew the engine. Well I replaced it that works all is great. But I went to take it on a test drive. And I didnt have the temperature sensor pushed in all the. And it would read the temp if I turned off the car. The gauge would spike up to how warm it was. Everything was good. But I forgot to turn the key to the on position before throwing it in first. And just roll starting it. And well it was done. I replaced the slave cylinder and the clutch. It feels like it's going into gear. But it's not I can take my foot off the clutch and she still runs. Even after the new installment. I didnt replace the pressure plate because it still looked good. I took apart the trans. And nothing looks damage inside. I'm at a stand still. Need some help cause I'm lost now.
 
1 - 2 of 2 Posts
Top