Focus Fanatics Forum banner

How to Replace Reverse Light Switch

16089 Views 7 Replies 7 Participants Last post by  sailor
So i bought my new car and found out my reverse lights didn't work. I traced it down tot he switch being bad. Well i searched all over for pictures of where this thing was located and how to get at it. So here's my how to on it.

1. Jack up car, use jack stands to hold it up, then place the jack under the transmission to hold it for later. Now remove the battery.



2. Remove plastic that battery sits in there are 3 bolts. (sorry forgot to take a picture)


3. Remove Transmission mount. Make sure you put a jack or a jack stand under the transmission as a safety precaution because you do need to remove the transmission mount.



4. After you have finished removing all of those bolts. Pull the plastic clips that are holding in a variety of wires onto this metal mount. Then pull the metal out of the way. You should be able to see the switch.




5.To remove the switch you will need to 1 or 2 things. a 22mm deep socket or you are going to have to remove the piece that is mounted on the transmission it has 3 bolts on it listed below. ( i suggest you get some liquid wrench or something to help ya with these bolts.)



6. Finish removing the old switch and swap out the old one and plug in all back together.






If you have any questions feel free to ask!
  • Like
Reactions: FocusedSlayer
1 - 1 of 1 Posts

· Captain Retard
Joined
·
2,872 Posts
Get a haircut you hippy^^^^^. Good write up and damn, what a place to put it eh?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top