Focus Fanatics Forum banner
1 - 4 of 4 Posts

· Registered
961 Posts
Discussion Starter · #1 ·
Well, I'm putting in new pistons and rods in my car (zetec engine) and kind of ran out of daylight, but I couldn't find where the bolts are that hold on the windage tray (a.k.a lower crankcase, according to the haynes manual). I have the oil pan off and I haven't taken out the oil pickup pipe yet, but I can't find these bolts for the life of me!! It could be that I ran out of daylight, but I doubt that's the case. So how do I go about taking this thing off so that I can get to the crank?
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.