[Jack The Ripper]

Hi

Tryed searching but found no luck. I'm trying to find out how to remove the stock SVT lip so that I can have it wrapped in 3M Carbon Fiber Vinyl. Does anyone know if it's bolted on with something or is it just clips?

Thanks!

 

[pasta]

its just clipped on you could prombably feel from bumper

 

[Jack The Ripper]

I can't tell if it's a screw & nut combo or just a clip. And I really don't feel like tearing off the front bumper to find out haha.

 

[3fan]

if you put the car on ramps i think you can see the clips
i kno where the bumper curves to go around to the front fender that those are clips so i dont see any reason why the whole thing wouldnt be clips

 

[Zanco]

There are a Combo of clips and bolts. There are multiple holes in the lip and bumper. Each hole for the lip had a clip over it. Then a screw-bolt goes in the bumper and screws into the clip. I believe all you will need is a 13mm wrench and you should be able to get it off. FYI it will be easier if you can get it high up and under the bump, when I put mine on I had a lift.

 

[3fan]

agreed, i got back under the car and looked and zanco is right it is a combo