Focus Fanatics Forum banner
1 - 1 of 1 Posts

· Registered
592 Posts
If its an automatic- Clutch pedal plug, drill through.
If its a manual- Go higher and punch through harness grommet.
If thats to much work (which it can be) then just drill a hole.

Your going to have more trouble fishing it through the stupid cardboard fiber mat thing. I usually run a thin piece of safety wire through my route first and pull it through. As mentioned its always better if you can get some rtv around the hole just seal it back up.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.