well, I made 164 whp 144 wtq w/ the crower II's which are more aggressive than the fr III's. I upgraded to a FR head w/ high lift valve springs/retainers, the whole shebang!! also did a 5 angle vavle job w/ 3 mm oversized valves. then of course all boltons!
how much power did your cams make?
Im looking into cams after i purchase my tuner since my bolt ons are pretty much complete now
I was wondering how much power are your upgraded camshafts putting down to the dyno after install?
Please Specify ATX/MTX
Camshaft Brand
stock or upgraded Cam gears,valve Springs, and lifters
type and stage?
thanks all
My Foci is ATX so im really interested to see those specs
I was wondering how much power are your upgraded camshafts putting down to the dyno after install?
Please Specify ATX/MTX
Camshaft Brand
stock or upgraded Cam gears,valve Springs, and lifters
type and stage?
thanks all
My Foci is ATX so im really interested to see those specs
1 - 3 of 8 Posts
ya, but it takes A LOT of head work!!!
ford racing makes a good set, but be prepared to pay up the butt!!!!
1 - 3 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Focus Fanatics Forum
A forum community dedicated to Ford Focus owners and enthusiasts. Come join the discussion about SVT performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
