Focus Fanatics Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have installed a 2006 Duratec 2.0L into my race boat hydroplane. I want to
wire the "variable tumble intake tuning valve" vacuum-electronic unit into my TECgt Electromotive Engine controls. In plain talk : The intake has a butterfly for each port built into the manifold. The control arm is activated by a three wire switched vacuum diaphram. How is this wired ?
Bill Walti
 

·
DTC P0606
Joined
·
3,364 Posts
Black/blue - pin 50 ECU module
Green/blue - ends up going to a splice S154 , then branches to pin 35/36 ECU (power hold relay)
White/red - pin 42 ECU module

Don't know how much help that is. The wiring diagram simply states IMRC for that pin/wire combination. It assumes you have a stock Ford PCM/ECU.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
Duratec in hydroplane

Thanks, BC ZX3
I relayed your info to Electromotive Controls and they are sending me a converted wiring diagram.
You have saved my racing weekend.
Relentless
 
1 - 4 of 4 Posts
Top