[Iceberg]

I have one sub in a box hooked up to my amp in my car. I bought another sub and another box! So what is the easiest way to hook it up to the amp? What kind of wires do i need, etc....
Any help would be appreciated!!

 

[dave30]

what are the specs on the amp/ subs? all you'll need as far as wiring goes is enough speaker wire to go from your amp to the new sub, but how you hook it up depends on the equiptment. depending on power, resistance, etc.. you may be best puttin it on its own channel, puttin it in series, parrallel... there are quite a few options....

 

[Iceberg]

The amp is 800w and the sub is a sony 1200w max 350w rms

 

[dave30]

is the amp 800w x 1? or is it 400x2, 200x4? and are both subs the same?

 

[Iceberg]

Sorry this is what it is
800W peak, 460W RMS (continuous) x 1 @ 4 ohms, bridged
460W peak, 230W RMS (continuous) x 2 @ 2 ohms
300W peak, 150W RMS (continuous) x 2 @ 4 ohms

Both subs are the same

 

[sa_pyro_ne]

is the sub single or dual voice coil?

 

[Iceberg]

its a single coil

 

[sa_pyro_ne]

You'll have to wire it one channel per sub. Should yield: 300W peak, 150W RMS (continuous) x 2 @ 4 ohms

 

[Iceberg]

what?

 

[sa_pyro_ne]

sorry, that one reply i screwed up on and edited it while i straightened out my facts.