[nov173]

Hey guys i am installing the FRPP kit on my car and i have the rear done. It started pouring so i stopped for the time being, but i started to do the front prior to this. I am having trouble loosening the nut on the stabilizer bar link to the strut. did anyone else have this trouble? It's hard to get any leverage in that space even with the wheel turned all the way, and i don't want to round off the nut at all! YES i did spray PB Blaster on it. Would a lil bit of heat to the nut be bad? Thanks in advance!!

mike

 

[1stTimeFocus00]

i actually used vice girps on that bolt because it was turning. Used a breaker bar to break it lose and then used reg socket wrench to take it off.