Focus Fanatics Forum banner
1 - 1 of 1 Posts

· Registered
4,763 Posts
Discussion Starter · #1 ·
Why would the CEL start to blink in a no start condition? The car doesn't even crank, however after the CEL stops blinking I cycle the ignition back and then go to start it again and it starts. Also the wrench lights been buggin me since this morning and since my xcal can't read wrench lights I have no idea what it is. I've read that the lock symbol and the CEL light illuminate at the same time if it's a pats problem but I only have the CEL, And like I said we bypassed the clutch pedal switch.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.