Focus Fanatics Forum banner
1 - 3 of 3 Posts

·
Registered
2005 ZX5 SES Duratec 2.0 L
Joined
·
13 Posts
Discussion Starter · #1 ·
A 2005 Duratec ZX5 SES is bound to have broken bits, interior and exterior. What is a good source for the shifter pushbutton, overhead sunglass holder, hood prop-rod clip, passenger power mirror cover, rear hatch fluid squirter, and various under-hood splash guard fasteners? Haven’t posted in ages, but GetFocusd is still going strong at 432K miles (repowered, re-transmissioned).
 

·
Registered
Joined
·
19,079 Posts
Clips and fasteners at parts store. All other at a scrapyard. And be careful as sun damage can screw up perfect looking parts depending on the base plastic type used there. Scratch a fingernail down it, if it powders under finger the part is sunstruck and will break super easy. Oily based plastics not so much of a problem but Ford uses polystyrene on some and it is fragile after sitting in the yards. Twist the part a little to see if it shatters without twisting at all, no good if it does.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top