Focus Fanatics Forum banner
1 - 3 of 3 Posts

· Aggresive Not Crazy
Joined
·
1,986 Posts
Discussion Starter · #1 ·
So i had my clutch replaced in septmenber. well just recently my throttle has been sticking and it kicks my whole car. why wouldnt the mounts absorb it? also while the clutch pedal is pressed and the throttle is tapped, it feels like it wants to start accelerating. Clutch fluid is fine mabye needs a top off.

WHATS WRONG WITH MY CAR...[:(] [:(] [bash] [bash] [?|] [?|] [thumbd]
 

· Registered
Joined
·
583 Posts
My throttle isn't sticking but after replacing my clutch with an aftermarket one if I put it in neutral and or hold the press the clutch pedal all the way down and rev the engine, at around 4000rpm it will start lurching forward. It recently went out again and I am sure it is either the clutch slave or the throw out bearing. I just replaced the clutch master cylinder and it wasnt that so it has to be one of the other two things. Good luck and you might take it back and have whoever did it check it out again.
 

· Registered
Joined
·
65 Posts
Desludge your throttle body, its not hard. You don't even need to take it off. Rag, can of throttle plate cleaner. Bang. Annoying pedal gone. Is your clutch pedal the same as before? Those hydraulics are a pain in the ass to bleed.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top