Focus Fanatics Forum banner

1 - 6 of 6 Posts

·
Banned
Joined
·
85 Posts
Discussion Starter · #1 ·
hey guys i need to replace the EGR Valve from my 00' ZX3 but the part looks so bad its rusty and also its so tight and hard, and im trying to loose it but im scared cuz i dont want to broke it or something so im need to replace it ASAP so any suggestions?????

and in case of i broke it, its hard to intstal a new EGR LINE ???? or its just to remove and replace????
 

·
Flat Black King
Joined
·
8,203 Posts
are u talking about the hose that runs from the motor to the pcv valve or the 90 degree elbow on the pcv hose?
 

·
Registered
Joined
·
16 Posts
no hes talking about the pipe that goes from the exhast manifold to the intake.

try some liquid wrench on all the studs and just go slow you will probaly break a stud, i did but hopfully you dont. the studs arent to hard to replace just time comsuming.
 

·
Registered
Joined
·
1,036 Posts
Try some pb blast that seems to work the best you might need more leverage to break the line loose just try not to bend or break the tube.
 
1 - 6 of 6 Posts
Top