Focus Fanatics Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter #1
i dont have pics of paper cause i cant find my camera are but the results were.

126.5 max power @6000 rpm

124.4 max torque @4250 rpm

i will have pics of it soon. this was with a 2.1/4 magnaflow exhaust and k&n cai.
 

·
Registered
Joined
·
281 Posts
Discussion Starter #3
 

·
Registered
Joined
·
301 Posts
dosent look like that hp curve had peaked yet. might have had a few more top end horses if you had held it a little longer! very nice either way. \m/ d><b \m/
 

·
Registered
Joined
·
281 Posts
Discussion Starter #5
ya i did a 3rd gear pull and only wanted to go up to 6,500rpm
 

·
Registered
Joined
·
930 Posts
That's pretty close to my intake/exhaust dyno. Prolly with in the margin of error actually.
 

·
GreyRice WOoT!
Joined
·
10,786 Posts
nice numbers, for most stock, once i finnish mine im curious what ill get...
 

·
Registered
Joined
·
1,765 Posts
just like metallicanick78 said i think you left some horses unseen, and i think that is a mustang dyno, some one correct me if im wrong but i think u can add some numbers to that dyno to get what you would get on a dyno jet.


but i think those are good number just conv to dyno jet or waht real numbers should look like.
 

·
Registered
Joined
·
125 Posts
Is this a manual??
 

·
Registered
Joined
·
281 Posts
Discussion Starter #14
it was a mustang dyno and yes it was a standard. this was done at performance plus in saskatoon. they had a dyno day $20 got you a pull and a shirt lol.
 

·
FF #1 Most Wanted
Joined
·
6,890 Posts
Mustang dyno's usually show high numbers and essentially show crank power with about -5% tolerance.
 
1 - 17 of 17 Posts
Top