Focus Fanatics Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
So I've seen a couple of threads showing how an exhaust header made for the '08-'11 Duratec 2.0L will bolt up to the '12-up Ti-VCT motor. I was wondering if the same could be said for an intake manifold? Cosworth makes a manifold for the Duratec engine and it's for sale on FSWerks's website:

http://www.fswerks.com/collections/...d-ford-focus-duratec-kk3240?variant=264211226

I was wondering if this'd be compatible (with or without minor modifications) on my '13 SE. Would look hella cool under the hood but I'm wondering if there'd be any worthwhile performance gain from it as well. I think Mountune also makes one for the Duratec (albeit for a whole lotta $$$$). Thoughts?
 

·
Focus Addict
Joined
·
14,132 Posts
The intake side has different ports, and is not interchangeable.
 
1 - 4 of 4 Posts
Top