[crobro24]

i recently bought headlgihts dual with the halo rims off ebay..lookin good gonna paint them but didnt come with instructions about wiring the halos to......i was gonna slpice them in with the grille lights i also got some nuts bolts and washers dont know what them are for
if anyone has some tips to help me out thanx!!!

[^]

 

[microtonal]

How many halos on each headlight ?
How many wires per headlight for the halos ?

 

[crobro24]

black and a red for the halos one on each light,not to sure bout them nuts and bolts thou

 

[microtonal]

Black goes to ground and red goes to anything with 12VDC(Fog lights, turn sigs or you can wire up something to turn it on and off using a switch in the cabin.
Advise you put 300 or 330 ohm/half watt resistor in series with red wire or your halo's may burn up in a few months.

 

[neojen]

halos are nice..

 

[FuriousRage]

I also just recently bought the same headlights - Mine came with directions to wire the halo's to the park/signal side marker lamp.

But I want to change my foglights so that they will turn on without the headlights being on. Can I do that easily?

 

[microtonal]

But I want to change my foglights so that they will turn on without the headlights being on. Can I do that easily?

Look in the How To section on the main page of this forum. It's on the left hand side. This a Fog Light Mod to allow you to turn on your fog lights without the HL's being on.

 

[Solaris]

i wired my halos to the foglights and then set up the independant foglight mod worked out nice

 

[FuriousRage]

After installing the headlights, they seem it be a bit misdirected.
Did you have this problem?

They are aimed too high - The adjustor in the back of the housing seems to only move them left to right?

 

[dank]

keep turning the adjuster , it will move them up and down ....... unless its broken, which happens

 

[microtonal]

As dank said, the adjuster screw should move the HL up and down.
Turn the adjuster toward the driver side to make them go up and toward the passenger side to bring them down. It takes a lot of turns to see any adjustments.

Use the link below to help align your HL's. If the screw does not adjust the HL's, you may have a broken adjuster.

Click Here