Focus Fanatics Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Ok I just finished putting a new engine in after hydrolocking my old one, the engine I got was from an auto and my car is a manual ( you all know where I'm going with this) got down to the moment of truth...crank no start, no fuel, no spark....obviously. I really don't feel like pulling the tranny off again just to change the crank sensor mounting plate. I have read on here that people have found a longer crank sensor to install, but have found no luck finding one. If anyone can point me in the right direction to find one it would be greatly appreciated! Or any other options would be helpful too, thank you in advance!
 

·
Registered
Joined
·
520 Posts
pull your tranny and swap mounting plates.
It's not longer it's mover over to the side.
 

·
Registered
Joined
·
520 Posts
ya gotta hate that. stupid putting the bolt inside the bell housing.
 
1 - 4 of 4 Posts
Top