Focus Fanatics Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,068 Posts
Discussion Starter #1
Anyone know what the general cost of labor is for working on an existing exhaust system:

This is what I need done....

-Remove and re-install exhaust but tweak the hangers so the exhaust sits up high and straight.
-Cut out one of the resonators and weld in a bigger one that I already own.
-Weld all the seams.

Trying to figure out if it's worthwhile or scrap what I have and go Borla for 5 or 6 hundred.

Thanks.
 

·
Registered
Joined
·
2,807 Posts
I'm not sure exactly where you are located, but I have freqented Muffler Man on Kingsway in Burnaby. I have had cracked ORPs patched and welded for $20. i think most of the work they do is custom. just give them a call or stop buy and they could easily quote for you.
 

·
Registered
Joined
·
533 Posts
Shop time is usuallyour around 100-120 here in calgs, but should not tare more then 3 hours at the most.
 
1 - 5 of 5 Posts
Top