Focus Fanatics Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
Hey people, basically im planning on upgrading my exhaust system, im going to be doing the ST170 (SVT) manifold swap on my 1.8zetec and was wondering if i bought a catback system designed for an ST170(SVT) would all the hangers be in the right places? The reason i ask this question is because i understand that the bolt holes on the ST170 Cat are different to the standard zetec, therfore since i havnt bought a catback exhaust yet i wouldnt have to modify the bolt holes or would i?

Hoping for my exhaust to emit a nice tone like this :) :

http://www.youtube.com/watch?v=XeF95TNywhg

Help would be greatly appreciated :)

Thanks
 

·
Registered
Joined
·
345 Posts
i know for the us zetec when compared with the svt the svt header puts the cat under the car where the zetec header is short and puts the cat in front of the engine, thats why if you get a long svt header for a zetec most of the time you just eliminate the cat altogether, for my zetec exhaust there are 3 hangers 1 right after the flex pipe, 1 before the rear suspension, and 1 at the rear bumper dunno if that helps but its all i can suggest
 
1 - 2 of 2 Posts
Top