Focus Fanatics Forum banner
Cancel

Broken bolt on hatch trim strip

1008 Views 5 Replies 4 Participants Last post by  TerryB, 
K
3
Anyone ever have this happen? I was removing my hatch trim strip (holds the license plate lights) to paint behind it and snapped one of the bolts connecting it to the car. It must have been stuck on a bit of rust or something, but I over torqued it and it just snapped. Any ideas on how to fix this? If I could get the broken "nub" out I could screw a new bolt in, but it's too small to get a good grip on.

Attachments

See less See more
Reply
Save
Like
1 - 1 of 6 Posts
02SilverSVT
just use some super glue and duct tape when you put it back on, it'll be fine......lol

there's at least two more bolts that are good, right? you should be fine with the other bolts holding it on I would think.
Reply
Save
Like
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Focus Fanatics Forum
A forum community dedicated to Ford Focus owners and enthusiasts. Come join the discussion about SVT performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Technical Chat Ford Focus Builds & General Showroom MK3 Focus SVT Performance (2002-2004) MK1 Focus

Top Contributors this Month

View All
P
A
H
Recommended Communities
Community avatar for Ford Focus ST Forum
Ford Focus ST Forum
78K+ members
Community avatar for AVS Forum
AVS Forum
1M+ members
Community avatar for Ford Maverick
Ford Maverick
7K+ members
Top