Focus Fanatics Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1 (Edited)
Hey everyone,
I went to get my new 35 watt 6000k HID's installed today. They got put in and when he cut the engine on my car said the output was too low so the lights cut off after 30 seconds. I did some further research and it looks like I need an error code eliminator to stop the computer from shutting my lights off. Will this work for my 2012 focus?
 

·
DTC P0606
Joined
·
3,364 Posts
Can't help you other than to say it's "farad" - not ferret - and farads is a measure of capacitance. Electrical resistance is measured in ohms.

Now that you know the proper terms, you might try Google.
 

·
Premium Member
Joined
·
21,250 Posts
I hope you saved the OEM equipment. Experiences on this board with aftermarket HID conversions have not been good. It's not a Ford thing, it's the inferior quality of the parts. There might be a day when you'd prefer to swap back.
 
1 - 3 of 3 Posts
Top